11 33 054 Removing and installing/renewing rocker arms on right side (N63)
WARNING: This page is about a different variant/trim than selected.
Special tools required:
- 11 4 480
(cylinder bank 1 to 4)
Necessary preliminary work:
- Remove INLET AND EXHAUST ADJUSTMENT UNIT on right side.
- Remove right INLET CAMSHAFT .
- Remove right EXHAUST CAMSHAFT .
IMPORTANT:
Used rocker arms (1) may only be reused in the same position.
Tolerance classes are not required.
Tolerance classes are not required.
Remove rocker arm (1) and set down in neat order in special tool 11 4 480 .
Install rocker arm (1).
Align all rocker arms (1) straight.
Assemble engine.