11 65 180 Removing and installing/replacing top heat shield (S63)

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: Do not carry out test drives without heat shield (risk of fire!) .

Necessary preliminary tasks:

Release retaining clip (1).

Detach wire ring (2) and set down behind oxygen sensor.

Fig 1: Identifying Retaining Clip And Wire Ring

Courtesy of BMW OF NORTH AMERICA, INC.

Release bolts (1) through 180°.

Tightening torque 11 65 3AZ .

Fig 2: Identifying Heat Shield Bolts

Courtesy of BMW OF NORTH AMERICA, INC.

Release bolts (1) through 180°.

Tightening torque 11 65 3AZ .

Fig 3: Identifying Heat Shield Bolts

Courtesy of BMW OF NORTH AMERICA, INC.

Lift out heat shield.

Installation note:

Clip in heat shield (1) into retaining clip, see arrow.

Fig 4: Identifying Heat Shield Retaining Clip

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble engine.