11 61 365 Removing and installing/replacing front left charge air duct (N55): Notes

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

Release screw (1).

Tightening torque 17 10 4AZ .

Fig 1: Identifying Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock snap fastener (1).

Detach charge air duct (2) from charge air cooler connection (3).

Installation note:

The seal inside the snap fastener must be coated with anti-friction agent.

Charge air duct (2) must snap audibly into place!

Fig 2: Identifying Charge Air Duct, Charge Air Cooler Connection, And Snap Fastener

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten hose clamp (2).

Release charge air duct (3) from gaiter (1).

NOTE: Remove charge air duct (3) in upward direction by simultaneously turning anti-clockwise (see Fig 3 of arrow).

Fig 3: Removing Charge Air Duct

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble engine.