Overview of tightening torques
WARNING: This page is about a different variant/trim than selected.
| Use in Activity: 19, 21 |
| Catalytic converter to cylinder head |
| M8 |
21 Nm |
| Use in Activity: 19, 21 |
| Holder of catalytic converter to cylinder head |
| M8 |
21 Nm |
| Use in Activity: 19, 21 |
| Crankcase ventilation to cylinder head cover |
| M6 |
10 Nm |
| Use in Activity: 19, 21 |
| Catalytic converter to turbocharger |
| Replace clamp |
13 Nm |
| Use in Activity: 19, 21 |
| Holder of catalytic converter to catalytic converter |
| M8 |
21 Nm |
| Use in Activity: 20, 22 |
| Holder for monitoring sensor to cylinder head cover |
| M6 |
10 Nm |
| Use in Activity: 23, 24 |
| Heat shield to heat shield |
| M6 |
10 Nm |
| Use in Activity: 24 |
| Holder for acoustic cover to cylinder head cover |
| M6 |
10 Nm |
| Use in Activity: 25, 27 |
| Monitoring sensor to engine |
| M18 x 1, 5 |
50 Nm |
| Use in Activity: 26, 28 |
| Control sensor to engine |
| M18 x 1, 5 |
50 Nm |
| Use in Activity: 29 |
| Clean air pipe to exhaust turbocharger |
| M6 |
10 Nm |
| Use in Activity: 30 |
| Charge air line to charge air cooler |
| Replace clamp |
3, 5 Nm |
| Use in Activity: 30 |
| Charge air line to exhaust turbocharger |
| Replace clamp |
3, 5 Nm |
| Use in Activity: 31 |
| Clamp to air duct |
| |
3 Nm |
| Use in Activity: 34 |
| Exhaust system to catalytic converter |
| M8 |
20 Nm |
| Replace nuts |
|
| Use in Activity: 34 |
| Holder of exhaust system to exhaust system |
| M8 |
22 Nm |
| Use in Activity: 34 |
| Holder of exhaust system to transmission |
| M8 |
22 Nm |
| Use in Activity: 35 |
| Rear underbody protection to body |
| Screw |
3 Nm |
| Nut |
2.5 Nm |