11 14 250 Removing and installing/sealing rear coolant end cover (N63)

WARNING: This page is about a different variant/trim than selected.

Special tools required:

WARNING: Risk of scalding!
Only perform this work after engine has cooled down.

Recycling:

Catch and dispose of drained coolant in a suitable collecting vessel.

Observe country-specific waste disposal regulations.

Necessary preliminary work:

Release all screws in area (1).

Tightening torque 11 14 5AZ .

Remove end cover.

NOTE: Clean sealing surfaces with special tool 11 4 470 .

Fig 1: Locating Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Replace profile seal (1).

Fig 2: Identifying Profile Seal

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble engine.