11 13 020 Removing and installing/replacing lower oil sump section (S63)
WARNING: This page is about a different variant/trim than selected.
Necessary preliminary tasks:
- Release OIL DRAIN PLUG and drain engine oil.
Unlock plug connection on oil level sensor and disconnect.
Release screws (1) along line.
Tightening torque 11 13 3AZ .
Remove lower oil sump section.
Installation note:
Clean sealing surfaces.
Replace gasket.
NOTE:
When replacing oil sump bottom section:
- Remount the oil condition sensor.
- Renew the sealing ring of the oil condition sensor.