11 13 020 Removing and installing/replacing lower oil sump section (N63)
WARNING: This page is about a different variant/trim than selected.
Necessary preliminary work:
- Remove underbody protection at front and rear. See REMOVING FRONT UNDERBODY PROTECTION and REMOVING REAR ENGINE UNDERCOVER .
- Release OIL DRAIN PLUG and drain engine oil.
- Remove STIFFENING PLATE (AWD only).
Unlock plug connection (1) on oil level sensor and disconnect.
Release screws (2) along line.
Tightening torque 11 13 3AZ .
Remove lower oil sump section (3).
Installation note:
Clean sealing surfaces.
Replace gasket.
Replace screws.
When replacing lower oil sump section:
Convert oil level sensor.
Replace sealing ring.
NOTE:
Procedure with four-wheel drive.
Unlock plug connection (1) on oil level sensor and disconnect.
Release screws (2) along line.
Tightening torque 11 13 3AZ .
Remove lower oil sump section (3).
Installation note:
Clean sealing surfaces.
Replace gasket.
Replace screws.
When replacing lower oil sump section:
Convert oil level sensor.
Replace sealing ring.