11 13 000 Removing and installing, sealing or replacing oil sump (N55, AWD)

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: Aluminium screws/bolts are permitted with and without color coding (blue).
Aluminium screws/bolts must be replaced each time they are released .
For reliable identification:
Aluminium screws/bolts are not magnetic .
Jointing torque and angle of rotation must be observed without fail (risk of damage) .

Necessary preliminary tasks:

Remove LEFT CHARGE AIR DUCT .
Drain and add ENGINE OIL .
Remove FRONT AXLE DIFFERENTIAL .
Remove bearing support.
Detach power steering pump and set it aside (Dynamic Drive only). See REMOVING HYDRAULIC POWER STEERING PUMP (WITH DYNAMIC DRIVE) and REMOVING HYDRAULIC PUMP FOR DYNAMIC DRIVE .
Remove ENGINE SUPPORT ARM .
Detach deflecting element and holder from oil sump.

NOTE: The lines must be detached from the oil sump on vehicles with automatic transmission; if necessary, detach oil pump and place to one side.

Release bolts (3) on transmission.

Tightening torque 11 13 6AZ .

Detach return hose (2).

IMPORTANT: For vehicles with four-wheel drive or automatic transmission, bolts of different lengths are installed for mounting the oil sump.
Observe different tightening torques.

Release bolts along line (1).

Fig 1: Identifying Return Hose And Bolts

Courtesy of BMW OF NORTH AMERICA, INC.

For vehicles with four-wheel drive or automatic transmission:

Tightening torque 11 13 2 AND 3AZ .

Additionally for vehicles with four-wheel drive:

Tightening torque 11 13 4AZ .

Installation note:

Replace aluminium screws.

If necessary, release nuts (4). Remove oil level sensor.

Tightening torque 11 13 7AZ .

Installation note:

Replace sealing ring.

IMPORTANT: There must be no adhesive residues in the lower crankcase section retaining threads.
Clean retaining threads and sealing surfaces.

Installation note:

Replace all gaskets.

Assemble engine.