11 00 Mounting engine on assembly stand (N55)
WARNING: This page is about a different variant/trim than selected.
Special tools required:
IMPORTANT:
Aluminium screws/bolts must be replaced each time they are released
.
Aluminium screws/bolts are permitted with and without color coding (blue).
For reliable identification:
Aluminium screws/bolts are not magnetic .
Jointing torque and angle of rotation must be observed without fail (risk of damage) .
Aluminium screws/bolts are permitted with and without color coding (blue).
For reliable identification:
Aluminium screws/bolts are not magnetic .
Jointing torque and angle of rotation must be observed without fail (risk of damage) .
Necessary preliminary tasks:
- Remove ENGINE
Use special tool 11 8 541 to mount engine on special tool 00 2 300 .
Mount engine or engine block with special tool 11 8 542 on 11 8 541 .