13...... Removing intake duct (N63)

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks: Remove TENSION STRUTS on left and right

NOTE: Picture describes the left side, the procedure for the right side is identical.

Press in catch (1).

Feed out intake duct (2) towards top.

Fig 1: Removing Intake Port

Courtesy of BMW OF NORTH AMERICA, INC.

Press in catch (1).

Detach intake duct (2) towards rear and remove.

Fig 2: Detaching Intake Duct Toward Rear

Courtesy of BMW OF NORTH AMERICA, INC.