Overview of tightening torques
WARNING: This page is about a different variant/trim than selected.
| Use in Activity: 31, 33 |
| Connecting line on cylinder head cover |
| M6 x 18 |
10 Nm |
| Use in Activity: 32 |
| Engine wiring harness to engine |
| M8 |
10 Nm |
| Use in Activity: 34 |
| Oil filler neck on cylinder head cover |
| M6 x 20 |
8 Nm |
| Use in Activity: 35, 36 |
| Carrier plate holder on cylinder head cover |
| M6 x 20 |
8 Nm |
| Use in Activity: 41 |
| Expansion tank to body |
| M6 |
10 Nm |
| Use in Activity: 42 |
| Oil reservoir to coolant expansion tank/holder |
| M6 |
8 Nm |
| Use in Activity: 42 |
| Oil reservoir to wheel arch |
| M6 x 37 |
10 Nm |
| Use in Activity: 43, 44 |
| Clean air pie to turbocharger |
| M6 |
10 Nm |
| Use in Activity: 45, 46 |
| Charge air hose to exhaust turbocharger |
| Screw clamp |
3, 5 Nm |
| Use in Activity: 47 |
| Electronics box, lower section to body |
| |
8 Nm |
| Use in Activity: 47 |
| Grounding cable to ground connection |
| M8 |
21 Nm |
| Use in Activity: 49 |
| Clamp to air duct |
| |
3 Nm |
| Use in Activity: 51 |
| Suspension cross-brace in engine compartment, front |
| M10 x 25 |
Tightening torque |
56 Nm |
| M10 x 47 |
Jointing torque |
30 Nm |
| Replace screws |
Angle of rotation |
90 ° |
| Use in Activity: 54 |
| Battery earth lead |
| M6 |
5 Nm |