11 11 Engine Block, Cylinder Crankcase N63O1
WARNING: This page is about a different variant/trim than selected.
ENGINE BLOCK, CYLINDER CRANKCASE SPECIFICATION
| Bore Ø stage 0(1) | mm | 89.000+0.02 | ||
| Bore Ø stage 00 (1) | mm | 89.250+0.02 | ||
| Bore Ø stage 1 (1) | mm | 89.500+0.02 | ||
| Permitted out-of-round of cylinder bore (1) | mm | 0.01 | ||
| Permitted conicity of cylinder bore (1) | mm | 0.01 | ||
| Permissible total wear tolerance between piston and cylinder (engine operated) | mm | 0.15 | ||
|
||||