54 10 120 Replacing sealing for glass tilt sunroof cover

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

NOTE: Follow REPAIR INSTRUCTIONS for bonded gaskets on glass tilt sunroof.

NOTE: To ensure that sealing is correctly positioned when reinstalled, pencil in old sealing position using a suitable implement.

Pull off sealing (1) for glass tilt sunroof from body.

Installation note:

Clean bonding surface with adhesive remover (sourcing reference: BMW Parts Department).

Partially pull off protective film from adhesive tape (2).

Press sealing (1) without stretching (squashing).

Stick on sealing (1) in sections.

IMPORTANT: Do not touch adhesive area.
Surface temperature ≥20 °C
Incorrect bonding of the sealing will result in leaks.

Fig 1: Installing Sealing

Courtesy of BMW OF NORTH AMERICA, INC.