33 41 Wheel Bearings
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATIONS - WHEEL BEARINGS
| Type | Thread | Tightening specifications | Dimension | ||
|---|---|---|---|---|---|
| 1AZ | Output shaft on drive flange hub | F01/F02/F04/F06/F07/F10/F11/F12/F13/F18/F25/F26 | M27 | Replace collar nut. Jointing torque and angle of rotation must be observed without fail. |
|
| Jointing torque | 100 Nm | ||||
| Angle of rotation | 45 ° | ||||
| F06 M6/F10 M5/F12 M6/F13 M6 | M16 | Observe the repair instructions. Replace collar bolt and spring. |
|||
| Jointing torque | 50 Nm | ||||
| Angle of rotation | 155 ° | ||||
| F03 | M27 | Replace collar nut. | 420 Nm | ||
| 2AZ | Wheel bearing to wheel carrier | F01/F02/F04/F06/F07/F10/F11/F12/F13/F18/F25/F26 | M12 | Replace screws. | 100 Nm |