33 11 Rear Differential Case with Cover
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATIONS - REAR DIFFERENTIAL CASE WITH COVER
| Type | Thread | Tightening specifications | Dimension | ||
|---|---|---|---|---|---|
| 1AZ | Case Covers TRANSMISSION ALLOCATION |
F01/F02/F06/F07/F10/F11/F12/F13/F18 | M12 | 205AL 225AL |
140 Nm |
| F01/F02/F03/F04/F25/F26 | M10 | 235K 235L 215LW |
90 Nm | ||
| F25/F26 | M10 | 188LW | 55 Nm | ||
| 2AZ | Screw plug with O-ring | F01/F02/F03/F04/F06/F07/F10/F11/F12/F13/F18/F25/F26 | M22 | Replace screw plug with O-ring. | 60 Nm |
| F06 M6/F10 M5/F12 M6/F13 M6 | M22 | Replace screw plugs with O-ring. | 45 Nm | ||
| 3AZ | Vibration absorber to holder/housing cover | F01/F02/F06/F07/F10/F11 | M12 | 100 Nm | |
| 4AZ | Adapter to front of rear axle differential | F06 M6/F10 M5/F12 M6/F13 M6 | M12 | 100 Nm | |
| 5AZ | Adapter to rear of rear axle differential | F06 M6/F10 M5/F12 M6/F13 M6 | M12 | 69 Nm | |
| 6AZ | Temperature sensor to oil sump | F06 M6/F10 M5/F12 M6/F13 M6 | 14 Nm | ||
| 7AZ | Servomotor to rear axle final drive | F06 M6/F10 M5/F12 M6/F13 M6 | M6 | 10 Nm | |
| 8AZ | Side lid to rear axle differential | F06 M6/F10 M5/F12 M6/F13 M6 | M8 | Tighten screws crosswise. | 32 Nm |
| 9AZ | Oil sump to rear axle differential | F06 M6/F10 M5/F12 M6/F13 M6 | M6 | 12 Nm | |
| 10AZ | Vibration absorber to adapter at rear of rear axle differential | F06 M6/F10 M5/F12 M6/F13 M6 | M8 | Insert screw with Loctite. Remove any adhesive residue from the thread.) |
21 Nm |