33 55 Anti-roll bar
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATIONS - ANTI-ROLL BAR
| Type | Thread | Tightening specifications | Dimension | ||
|---|---|---|---|---|---|
| 1AZ | Retaining bracket, anti-roll bar to rear axle support | F01/F02/F03/F04/F07/F06/F10/F11/F12/F13/F18 | M10 | Replace screws. | 56 Nm |
| F25/F26 | M8 | Replace screw. | 34 Nm | ||
| 2AZ | Anti-roll bar link to anti-roll bar/swinging arm | F01/F02/F03/F04/F06/F07/F10/F11/F12/F13/F18/F25/F26 | M10 | Replace nuts. | 56 Nm |
| F01/F02/F03/F04/F06/F07/F10/F11/F12/F13/F18 | M12 | Replace nuts. | |||
| Jointing torque | 45 Nm | ||||
| Angle of rotation | 45 ° | ||||
| 3AZ | Vibration absorber to anti-roll bar bracket | F01/F02/F06/F07/F10/F11/F12 | Replace screw. | 19 Nm | |
| 4AZ | Anti-roll bar link to wheel carrier | F25/F26 | M10 | Replace screw. | 56 Nm |