61 71 004 Adjusting washer jets for windscreen washer system
WARNING: This page is about a different variant/trim than selected.
Triple nozzle system
The spray jets should hit the middle of the wiping area.
Adjustment values in mm
A1= 200
A2= 400
B1= 400
B2= 400
C1= 450
C2= 450
D1= 230
D2= 350
E1= 500
E2= 350
F1= 550
F2= 350
NOTE:
If necessary, remove adhesive residue from windscreen.
Fill up with washer fluid.
NOTE:
Washer jets are preset; in case of customer complaint, the setting can be adjusted as needed.
Changes in the setting must take into account the possible driving situations (high/low speed; with/without washing additive) and must be performed with care.
If necessary, adjust left/right or middle washer jet (1) by way of screw (2).