61 31 334 Removing and installing or replacing grip cover for gear selector switch

WARNING: This page is about a different variant/trim than selected.

Special tools required:

Carefully unclip cover (1) from gear selector switch (3) using special tool 00 9 322 at points (2) and remove in direction of arrow.

Fig 1: Removing Cover From Gear Selector Switch Using Special Tool (00 9 322)

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Latch mechanism (1) must not be damaged or missing.

Fig 2: Identifying Latch Mechanism

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Latch mechanism (1) and guide (2) must not be damaged or missing.

Fig 3: Identifying Latch Mechanism And Guide

Courtesy of BMW OF NORTH AMERICA, INC.