61 31 014 Removing and installing/replacing Start/Stop switch

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: Incorrectly installed start/stop switch may cause the start/stop switch or MSA button to jam.
In the case of a fault message "Jammed start/stop switch or MSA button" check before replacing whether the start/stop switch has been correctly installed in the cover and is de-energized.
If necessary install the existing start/stop switch again and perform a functional check.

Necessary preliminary tasks:

Remove DECORATIVE STRIP ON DASHBOARD IN MIDDLE

Release screws (1) and remove Start/Stop switch (2).

Fig 1: Identifying Start/Stop Switch And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

The tab of the start/stop switch (1) be installed below the tab (2).

Fig 2: Identifying Installation Position Of Start/Stop Switch Tab

Courtesy of BMW OF NORTH AMERICA, INC.