61 14 010 Removing and installing/renewing power distribution box (on battery)

WARNING: This page is about a different variant/trim than selected.

WARNING: Observe SAFETY INFORMATION for handling the vehicle battery.

Necessary preliminary tasks:

Fold up covers (1). Unscrew nuts (2).

Tightening torque 61 21 2AZ .

Unscrew nut (3).

Tightening torque 61 21 3AZ .

Disconnect plug connection (4).

Fig 1: Identifying Covers, Nuts, And Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Press locking brackets (1) downwards and unclip in direction of arrow.

If necessary, using a screwdriver, expand locking bracket (1) at lower end and clip out.

Remove power distribution box (2) towards top.

Fig 2: Removing Power Distribution Box

Courtesy of BMW OF NORTH AMERICA, INC.