61 35 107 Removing and installing or replacing junction box electronics

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

Necessary preliminary work:

Release screws (1) on junction box electronics (2).

Tightening torque 61 14 2AZ .

Fig 1: Identifying Junction Box Electronics And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Pull junction box electronics (2) out of bracket.

Installation note:

Make sure junction box electronics and plug connections (1) are correctly seated.

Fig 2: Identifying Junction Box Electronics And Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Delete transport mode.