61 35 015 Removing and installing (replacing) control unit for Car Access System
WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .
Necessary preliminary tasks:
- Disconnect NEGATIVE BATTERY CABLE
- Remove both battery earth leads at F03
- Remove TRIM PANEL FOR PEDAL MECHANISM .
Disconnect plug connection (1).
Release screw (2).
Tightening torque 61 35 1 AZ .
Remove control unit for Car Access System (3) in direction of arrow.
Installation note:
Feed guide (1) of control unit for Car Access System (2) correctly into associated mounting.
Replacement:
Carry out PROGRAMMING/ENCODING
For vehicles with rear-seat entertainment (RSE):
Teach in RSE master key via path:
- Body
- Rear seat entertainment system
- Teach in radio remote control
- Radio remote control