61 12 062 Replacing wiring harness on front bumper
WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
Read and comply with notes on HANDLING WIRING HARNESSES AND CABLES and cables.
Necessary preliminary tasks:
- Remove FRONT BUMPER PANEL
Disconnect all available plug connections.
The following plug connections may be available:
- (1) Fog light
- (2) Ultrasonic sensors
- (3) Central connector
- (4) Night Vision camera
- (5) Pedestrian protection sensor.
- (6) ACC
Unclip wiring harness (7) from bumper panel.
Remove wiring harness (7).
Installation note:
Make sure wiring harness (7) is laid correctly.