62 30 005 Removing and installing/replacing trim for Head-Up Display

WARNING: This page is about a different variant/trim than selected.

Special tools required:

Lever out trim for Head-Up Display (1) with special tool 00 9 317 at mounting points (2).

Feed cover for head-up display (1) in direction of arrow out of instrument panel trim (3) and remove.

Fig 1: Removing Head-Up Display Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Make sure retaining lugs (1) and (2) and sleeve (3) of cover for Head-Up Display (4) are correctly seated.

Fig 2: Identifying Retaining Lugs And Sleeve

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Make sure retaining lugs (1) and (2) are correctly seated on cover for Head-Up Display (3).

Fig 3: Identifying Retaining Lugs On Cover For Head-Up Display

Courtesy of BMW OF NORTH AMERICA, INC.