11 37 Variable valve gear
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATIONS - VARIABLE VALVE GEAR
| Type | Thread | Tightening specification | Measure | ||
|---|---|---|---|---|---|
| 1AZ | Slide block to cylinder head. | N55 | M6x23 | 10 Nm | |
| 2AZ | Torsion spring (throttle return spring) to cylinder head. | N55 | M6x20 | 10 Nm | |
| 3AZ | Electrical servomotor to cylinder head. | N55 | M6x16 | 10 Nm | |
| 4AZ | Oil spray nozzle to guide block. | N55 | M6x30 | 10 Nm | |
| 5AZ | Stop screw of eccentric shaft to cylinder head. | N55 | M6 | 10 Nm | |
| 6AZ | Valvetronic sensor to holder. | N55 | M6x20 | 8 Nm | |
| 7AZ | Holder for Valvetronic sensor. | N55 | M6x20 | 8 Nm | |