11 36 Variable camshaft control
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATIONS - VARIABLE CAMSHAFT CONTROL
| Type | Thread | Tightening specification | Measure | ||
|---|---|---|---|---|---|
| 1AZ | VANOS gear to inlet and exhaust camshafts | N63 | M10x1 | Replace screw | |
| Jointing torque | 30 Nm | ||||
| Torque angle | 90 ° | ||||
| 2AZ | Non-return valve VANOS to cylinder head | N63 | M14 x 1.5 | 13 Nm | |
| 3AZ | Solenoid valve holder to cylinder head | N63 | M6 | 10 Nm | |