11 28 V-ribbed belt with Tension and Deflection Element
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATIONS - V-RIBBED BELT WITH TENSION AND DEFLECTION ELEMENT
| Type | Thread | Tightening specification | Measure | ||
|---|---|---|---|---|---|
| Standard belt drive | |||||
| 1AZ | Belt tensioner with deflection pulley to engine block. | N55 | M10 x 90 | 38 Nm | |
| AZ | Belt tensioner with deflection pulley to engine block. | N55 | M10 x 103 | 38 Nm | |
| 2AZ | Deflection pulley 65 x 32 | N55 | M10 x 55 | 60 Nm | |
| 3AZ | Deflection pulley 75 x 32 | N55 | M10 x 55 | 60 Nm | |
| 4AZ | Holder for deflecting element to oil sump | N55 | M10 x 37 | 38 Nm | |
| 5AZ | Holder for deflecting element to oil sump | N55 | M10 x 30 | 38 Nm | |
| 6AZ | Deflecting element 75 | N55 | M10 x 55 | 56 Nm | |
| 7AZ | Deflecting element 90 | N55 | M10 x 55 | 56 Nm | |
| SGR belt (start alternator belt) | |||||
| 8AZ | Belt tensioner to crankcase (operating tensioner) | N55 | M10 x 90 | 38 Nm | |
| 9AZ | Belt tensioner to crankcase (start tensioner) | N55 | M10 x 55 | 38 Nm | |
| 10AZ | Deflecting element 75 | N55 | M10 x 55 | 56 Nm | |
| 11AZ | Holder for deflecting element to oil sump | N55 | M10 x 37 | ASA screw (exterior star handle) | 38 Nm |
| 12AZ | Holder for deflecting element to oil sump | N55 | M10 x 30 | ISA countersunk screw (interior star handle) | 38 Nm |