11 65 Turbocharger and Control
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATIONS - TURBOCHARGER AND CONTROL
| Type | Thread | Tightening specifications | Dimension | ||
|---|---|---|---|---|---|
| 1AZ | Exhaust manifold to turbocharger (D80 V-band clamp). | S63T 0 | M8 | Replace V-band clamp. | 13 Nm |
| 2AZ | Exhaust turbocharger to primary catalytic converter (D108 V-band clamp). | S63T 0 | M8 | Replace V-band clamp. | 13 Nm |
| 3AZ | Heat shield to heat shield, side. | S63T 0 | M6 x16 | 10 Nm | |
| 4AZ | Heat shield to cylinder head cover | S63T 0 | M6x12 | 10 Nm | |
| 5AZ | Heat shield, bottom, to crankcase/oil return cover. | S63T 0 | M6 x 12 | 10 Nm | |
| 6AZ | Heat shield to crankcase. | S63T 0 | M6 x 12 | 10 Nm | |
| 7AZ | Exhaust turbocharger heat shield and alternator to cylinder head. | S63T 0 | M6 x 12 | 10 Nm | |
| 8AZ | Bracket, electropneumatic pressure converter, to cylinder head. | S63T 0 | M6x18 | 10 Nm | |
| 9AZ | Electropneumatic pressure converter to bracket. | S63T 0 | M6 | 10 Nm | |
| 10AZ | Vacuum tank to oil sump | S63T 0 | M6x25 | 10 Nm | |