11 65 Turbocharger and Control
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATIONS - TURBOCHARGER AND CONTROL
| Type | Thread | Tightening specification | Measure | ||
|---|---|---|---|---|---|
| 1AZ | Exhaust turbocharger to cylinder head | N55 | M7 | Replace flange nut. | 13 Nm |
| 2AZ | Heat shield/retaining plate to crankcase top section | N55 | M6 x 16 | 8 Nm | |
| 3AZ | Pressure converter (EPDW) to cylinder head. | N55 | M6 x 16 | 8.5 Nm | |
| 4AZ | Pressure converter (EPDW) to holder with heat shield. | N55 | M6 x 16 | 9 Nm | |
| 5AZ | Vacuum unit (wastegate valve) to bracket | N55 | M6 | 7 Nm | |
| 6AZ | Lock nut to vacuum unit (wastegate valve) linkage | N55 | M6 | 7 Nm | |
| 7AZ | Bracket, vacuum unit (wastegate valve), to turbocharger | N55 | M8 | 7 Nm | |
| 8AZ | Holder to exhaust turbocharger. | N55 | M8 | 20 Nm | |
| 9AZ | Exhaust turbocharger holder to cylinder crankcase. | N55 | M8 | Replace microencapsulated screws | 20 Nm |