11 13 Oil sump
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATIONS - OIL SUMP
| Type | Thread | Tightening specifications | Dimension | ||
|---|---|---|---|---|---|
| 1AZ | Oil drain plug | N63 O1 | M12 x 1.5 | Replace sealing ring. | 25 Nm |
| 2AZ | Oil sump upper section to crankcase | N63 O1 | M8x25 M8x45 |
Replace microencapsulated screws | 27 Nm |
| 2AZ | Oil sump upper section to crankcase | N63 O1 | M6x25 | 10 Nm | |
| 3AZ | Oil sump, lower section to upper section | N63 O1 | M8x25 | Replace microencapsulated screws | 27 Nm |
| 4AZ | Screw plug, oil channel, to oil sump upper section | N63 O1 | M22x1.5 | Replace sealing ring. | 35 Nm |
| 5AZ | Oil condition sensor to lower oil sump section | N63 O1 | M6 | Replace O-ring. | 8.5 Nm |
| 6AZ | Oil temperature regulator to oil sump upper part (control valve) | N63 O1 | M33x2 | Replace sealing ring. | 100 Nm |