11 41 Oil pump with strainer and motor
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATIONS - OIL PUMP WITH STRAINER AND MOTOR
| Type | Thread | Tightening specifications | Dimension | ||
|---|---|---|---|---|---|
| 1AZ | Intake pipe with oil deflector to crankcase lower section (bedplate) | N55 | M6x30 | Replace screws Thread repairs exclusively with Al Heli-coil. Jointing torque and angle of rotation must be observed without fail. |
|
| Jointing torque | 4 Nm | ||||
| Angle of rotation | 90 ° | ||||
| 2AZ | Oil pump to bedplate | N55 | M8x123 | Replace screws Thread repairs exclusively with Al Heli-coil. Jointing torque and angle of rotation must be observed without fail. |
|
| Jointing torque | 10 Nm | ||||
| Angle of rotation | 180 ° | ||||
| N55 | M8x31 M8x37 |
Replace screws Thread repairs exclusively with Al Heli-coil. Jointing torque and angle of rotation must be observed without fail. |
|||
| Jointing torque | 10 Nm | ||||
| Angle of rotation | 90 ° | ||||
| 3AZ | Chain module to crankcase and oil pump | N55 | M6x16 | Replace screws Thread repairs exclusively with Al Heli-coil. Jointing torque and angle of rotation must be observed without fail. |
|
| Jointing torque | 4 Nm | ||||
| Angle of rotation | 45 ° | ||||
| 4AZ | Hydraulic valve of oil pump to crankcase | N55 | M6x16 | Jointing torque | 4 Nm |
| Angle of rotation | 45 ° | ||||
| 5AZ | Sprocket to oil pump | N55 | M8 | Jointing torque | 20 Nm |
| Angle of rotation | 45 ° | ||||
| 6AZ | Triangular drive to oil pump | N55 | M6x16 | Jointing torque | 4 Nm |
| Angle of rotation | 45 ° | ||||
| 7AZ | Chain tensioner to crankcase | N55 | M6x16 | 10 Nm | |