11 12 Cylinder Head And Cylinder Head Cover
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATIONS - CYLINDER HEAD AND CYLINDER HEAD COVER
| Type | Thread | Tightening specifications | Dimension | ||
|---|---|---|---|---|---|
| 1AZ | Cylinder head bolt | S63T 0 | M11 x 1.5 | Replace screws. | |
| Jointing torque | 30 Nm | ||||
| 1. Angle of rotation | 90 ° | ||||
| 2. Angle of rotation | 140 ° | ||||
| 2AZ | Cylinder head bolt to gear case cover | S63T 0 | M8x30 | 23 Nm | |
| 3AZ | Cylinder head cover to cylinder head. | S63T 0 | M6x30 M6x70 |
10 Nm | |
| 4AZ | Sealing cap to cylinder head. | S63T 0 | M6 | 10 Nm | |
| 5AZ | Securing eye to cylinder head. | S63T 0 | M8x22 | 22 Nm | |
| 6AZ | Non-return valve | S63T 0 | M14x1.5 | 20 Nm | |
| 7AZ | Ventilation connection | S63T 0 | M8x1 | Replace sealing ring. | 15 Nm |
| 8AZ | Oil filler neck to cylinder head cover. | S63T 0 | M6x20 | Replace sealing ring. | 14 Nm |
| 9AZ | Screw plug to rear of cylinder head | S63T 0 | M10x1 | Replace sealing ring. | 12 Nm |