11 51 Coolant pump with drive
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATIONS - COOLANT PUMP WITH DRIVE
| Type | Thread | Tightening specifications | Dimension | ||
|---|---|---|---|---|---|
| 1AZ | Coolant pump to crankcase | N55 | M8 x 26 | Replace screws. Thread repairs exclusively with aluminium Heli-coil threaded insert. Jointing torque and angle of rotation must be observed without fail. |
|
| Jointing torque | 10 Nm | ||||
| Angle of rotation | 90 ° | ||||
| 2AZ | Coolant pump to holder (only for vehicles with holder). | N55 | M8 x 27 | Replace screws. Thread repairs exclusively with aluminium Heli-coil threaded insert. Jointing torque and angle of rotation must be observed without fail. |
|
| Jointing torque | 10 Nm | ||||
| Angle of rotation | 90 ° | ||||
| 3AZ | Coolant hose between coolant pump and coolant thermostat. | N55 | L42-48 | 3 Nm | |
| 4AZ | Coolant hose between coolant pump and feed line. | N55 | L42-48 | 3 Nm | |
| 5AZ | Auxiliary water pump holder for EME to retaining bracket | N55, F10h/F01h/F02h/F30h | M6 x 14 | 10 Nm | |