11 24 Connecting Rods and Bearings
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATIONS - CONNECTING RODS AND BEARINGS
| Type | Thread | Tightening specifications | Dimension | ||
|---|---|---|---|---|---|
| 1AZ | Connecting rod bolt (new connecting rod with new connecting rod bolts) | N63 O1 | M9x1.25 | Release screws. Suction off crack surfaces. |
|
| 1. Jointing torque | 5 Nm | ||||
| 2. Jointing torque | 20 Nm | ||||
| 3. Jointing torque | 30 Nm | ||||
| 3. Angle of rotation | 75 ° | ||||
| 2AZ | 1. Special screw connection only with new connecting rod bolts. | N63 O1 | M9x1.25 | ||
| 1. Jointing torque | 5 Nm | ||||
| 2. Jointing torque | 20 Nm | ||||
| 3. Jointing torque | 30 Nm | ||||
| 4. Angle of rotation | 75 ° | ||||
| 2. Loosen screws | 5. Loosen screw. | 180 ° | |||
| 6. Jointing torque | 5 Nm | ||||
| 7. Jointing torque | 20 Nm | ||||
| 8. Jointing torque | 30 Nm | ||||
| 9. Angle of rotation | 75 ° | ||||
| 3. Loosen screws | 10. Loosen screw. | 180 ° | |||
| 11. Jointing torque | 5 Nm | ||||
| 12. Jointing torque | 20 Nm | ||||
| 13. Jointing torque | 30 Nm | ||||
| 14. Angle of rotation | 75 ° | ||||
| 4. Loosen screws | 15. Loosen screw. | 180 ° | |||
| 16. Jointing torque | 5 Nm | ||||
| 17. Jointing torque | 20 Nm | ||||
| 18. Jointing torque | 30 Nm | ||||
| 19. Angle of rotation | 75 ° | ||||