11 31 Camshaft
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATIONS - CAMSHAFT
| Type | Thread | Tightening specifications | Dimension | ||
|---|---|---|---|---|---|
| 1AZ | Tensioning rail and guide rail, cyl. 1 to 4, to crankcase | N63 | M10x1.25 | Renew screws Insert screws dry |
46 Nm |
| 2AZ | Tensioning rail and guide rail, cyl. 5 to 8, to crankcase | N63 | M8x1.25 | Renew screws Insert screws dry |
20 Nm |
| 3AZ | Guide rail to cylinder head | N63 | M14x1.5 | Replace sealing ring | 25 Nm |
| 4AZ | Slide rail to cylinder head | N63 | M7 | 15 Nm | |
| 5AZ | Chain tensioner to cylinder head | N63 | M7 | 13 Nm | |
| 6AZ | Camshaft bearing cap to cylinder head | N63 | M7 | 15 Nm | |
| 7AZ | Camshaft step bearing cap to cylinder head | N63 | M7 | 15 Nm | |