25 11 245 Replacing gearshift arm support bearing
WARNING: This page is about a different variant/trim than selected.
Necessary preliminary tasks:
- Remove propeller shaft . See 26 11 000 REMOVING AND INSTALLING COMPLETE PROPELLER SHAFT (INSERTED - FLEXIBLE DISC AT REAR) or 26 11 000 REMOVING AND INSTALLING COMPLETE PROPELLER SHAFT (CONSTANT-VELOCITY JOINT) .
Lever support bearing (1) with a short screwdriver out of mounting.
Pull support bearing off gearshift arm.
Installation note:
Grease bearing journal of gearshift arm.
Grease, refer to GEAR SHIFT MECHANISM -- OPERATING FLUIDS .
Fit support bearing (1) with recess (2) towards top rear onto mounting.