41 62 Rear lid
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATIONS - REAR LID
| Type | Thread | Tightening specifications | Dimension | ||
|---|---|---|---|---|---|
| 1AZ | Tailgate to tailgate hinge | F01/F02/F03/F04/F10/F12/F13/F06 | M8x19.5 8.8 | 18.5 Nm | |
| F11 | ISA M8x22 | 18.5 Nm | |||
| F07 | M8 countersunk screw | 18.5 Nm | |||
| F07 | M10 x 34 | 36 Nm | |||
| 2AZ | Tailgate hinge to body | F01/F02/F03/F04/F10/F12/F13/F06 | nut M8 | 18.5 Nm | |
| F07 | M8 x 20 | 18.5 Nm | |||
| F11 | ISA M8x22 | 27 Nm | |||
| F11 | ISA M6x12 | 10 Nm | |||
| 2AZ | Holder to hinge | F12 | M6x12 | 7.6 Nm | |
| 2AZ | Hinge holder to body | F12 | M8x16 | 18.5 Nm | |
| 3AZ | Hinge bolt | F01/F02/F03/F04/F10/F13/F06 | nut M8 | 18.5 Nm | |
| 4AZ | Tailgate lower section to hinge | F07 | M8 x 17 | 18.5 Nm | |
| 5AZ | Tailgate lower section hinge to tailgate | F07 | nut M8 | 18.5 Nm | |
| 6AZ | Limit position, tailgate to body | F07 | M6 x 21 | 6 Nm | |
| F07 | nutM6 | 6 Nm | |||
| F07 | M12x1.5 | 16 Nm | |||
| 7AZ | Ball pin for gas pressure spring to body | F07 | M10 | 36 Nm | |
| 8AZ | Earth cable to hinge | F12 | M6 | 8 Nm | |