26 11 020 Replacing center mount gaiter: Notes

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

Remove PROPELLER SHAFT .

NOTE: The propeller shaft is balanced.
The front and rear propeller shafts must be reassembled in the same position.
Detach gaiter (1) from groove (2).

Mark front propeller shaft (3) and rear propeller shaft (4) in one plane.

Fig 1: Marking Front Propeller Shaft And Rear Propeller Shaft In One Plane

Courtesy of BMW OF NORTH AMERICA, INC.

Pull apart propeller shaft.

Fig 2: Pulling Apart Propeller Shaft

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

If necessary, insert new clamping ring (1) into front propeller shaft (2).

Fig 3: Identifying Clamping Ring And Front Propeller Shaft

Courtesy of BMW OF NORTH AMERICA, INC.

Release gaiter (1) with screwdriver from groove (2) and pull off over longitudinal splines.

Installation note:

Apply an even coating of grease to longitudinal splines on shaft.

Grease, refer to BMW-SPECIFIED GREASE .

Observe markings and force front propeller shaft onto longitudinal splines (markings must be flush).

Push gaiter (1) during installation into groove (2) and make sure it is firmly fitted.

Fig 4: Identifying Gaiter And Groove

Courtesy of BMW OF NORTH AMERICA, INC.