27 10 070 Replacing output flange on rear transfer box (ATC 35L)

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: After completing work, check TRANSMISSION OIL LEVEL and top up if necessary.
Use only the approved TRANSMISSION OIL .

NOTE:

Replace output flange only together with a new radial shaft seal.
Operations for removal of output flange are identical to replacing RADIAL SHAFT SEAL for output flange.

Installation note:

Determine and note down dimension A of output flange (old and new).

Fig 1: Checking Output Flange Dimension A

Courtesy of BMW OF NORTH AMERICA, INC.

Determine and note down dimension B of output flange (old and new).

Fig 2: Checking Output Flange Dimension B

Courtesy of BMW OF NORTH AMERICA, INC.

Determine old dimension C, thickness of shim.

Fig 3: Identifying Shim Thickness

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Calculate thickness of new shim:

Add old dimension A of output flange (previous) and old dimension C of shim
Then subtract old dimension B from old result A+C
Subtract dimension B from dimension A of output flange (new)
Then subtract result of step 2 from result of step 1.