27 10 050 Replacing output flange for output to the front axle (ATC 35L)
WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
Do not move vehicle with drive power once propeller shaft has been removed.
Replace output flange only together with a new radial shaft seal.
After completion of work, check GEARBOX OIL LEVEL .
Use only the approved GEARBOX OIL .
Failure to comply with this requirement will result in serious damage to the transfer box!
Replace output flange only together with a new radial shaft seal.
After completion of work, check GEARBOX OIL LEVEL .
Use only the approved GEARBOX OIL .
Failure to comply with this requirement will result in serious damage to the transfer box!
Operation is identical to REPLACING RADIAL SHAFT SEAL FOR FRONT AXLE OUTPUT .