22 11 011 Replacing left engine mount (N63) - AWD

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

Lower FRONT AXLE SUPPORT .

Release bolt (1) and remove engine mount.

Tightening torque 22 11 2AZ .

IMPORTANT: Installation note:
To ensure play between engine mount and engine support arm, lower the engine completely before tightening the screw connection (engine mount/engine support arm).

Fig 1: Identifying Engine Mount Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Rubber part (1) of engine mount must point to center of vehicle.

Fig 2: Identifying Engine Mount Rubber Part

Courtesy of BMW OF NORTH AMERICA, INC.