22 11 001 Replacing right engine mount (N63)

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

Secure engine in INSTALLATION POSITION .
Remove rear UNDERBODY PROTECTION .
Release ENGINE SUPPORT ARM (left-hand drive models only)
Lower FRONT AXLE SUPPORT (right-hand drive models only)

Release screw (1).

Tightening torque 22 11 2AZ .

Remove engine mount.

IMPORTANT: Installation note:
To ensure play between engine mount and engine support arm, lower the engine completely before tightening the screw connection (engine mount/engine support arm).

Fig 1: Identifying Engine Mount Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Rubber part (1) of engine mount must point to center of vehicle.

Fig 2: Identifying Engine Mount Rubber Part

Courtesy of BMW OF NORTH AMERICA, INC.