LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2014 >> M6 2D Convertible, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 64 (Automatic Transmission - Repair - F13) >> Hydraulic/Electronic Control Components/Elements >> 24 30 101 Replacing oil reservoir (GA8HP70Z)

24 30 101 Replacing oil reservoir (GA8HP70Z)

WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
  • Do not let skin come in contact with transmission oil and do not inhale fuel vapors.
  • Wear protective gloves.
  • Ensure adequate ventilation.
IMPORTANT: Valid for vehicles manufactured from 08/2011 onward!
After completion of repair work, CHECK TRANSMISSION OIL LEVEL .
Use only the approved TRANSMISSION OIL .
Failure to comply with this requirement will result in serious damage to the automatic transmission!
IMPORTANT: When the hydraulic impulse storage is exchanged, the spring can be relaxed in pulses due to a mechanical fault in the hydraulic impulse storage, resulting in a sudden escape of oil.

Necessary preliminary work: 

Release screws (1) (M6x20).

Release screw (2) (M6x59).

Tightening torque 24 30 5AZ .

Carefully unlock connector (3) with screwdriver.

Carefully pull out oil accumulator.

Fig 1: Identifying Connector And Screws
G08488048Courtesy of BMW OF NORTH AMERICA, INC.
IMPORTANT: Mounting bolts of oil accumulator must  be replaced after removal.