13 62 Sensors for control unit
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATIONS - SENSORS FOR CONTROL UNIT
| Type | Thread | Tightening specifications | Dimension | ||
|---|---|---|---|---|---|
| 1AZ | Temperature sensor, coolant/oil | N63 B44 O 0/N63 B40 O 1/N63 B44 O 1 | M12x1.5 | 13.5 Nm | |
| 2AZ | Pressure sensor to intake manifold | N63 B44 O 0 | K50x14 | 3.5 Nm | |
| N63 B40 O 1/N63 B44 O 1 | 4 Nm | ||||
| 3AZ | Camshaft sensor to cylinder head | N63 B44 O 0 | M6 | 9 Nm | |
| N63 B44 O 0 | K50 | 5 Nm | |||
| N63 B40 O 1/N63 B44 O 1 | 8 Nm | ||||
| 4AZ | Crankshaft sensor to transmission | N63 B44 O 0 | M6 | 9 Nm | |
| N63 B40 O 1/N63 B44 O1 | M6 | 8 Nm | |||
| 5AZ | Knock sensor to crankcase | N63 B44 O 0/N63 B40 O 1/N63 B44 O 1 | M8 | 21.5 Nm | |
| 6AZ | Hot film air mass meter to upper section of intake filter housing | N63 B44 O 0 | K50x16 | 3 Nm | |
| N63 B40 O 1/N63 B44 O 1 | 4 Nm | ||||
| 7AZ | Pressure sensor to intercooler | N63 B44 O 0/N63 B40 O 1/N63 B44 O 1 | M6 | 3.2 Nm | |
| 8AZ | Intake filter housing upper section to intake filter housing lower section | N63 B44 O 0/N63 B40 O 1/N63 B44 O 1 | PT50x26/12 | 3.3 Nm | |
| 9AZ | Clamp to air duct | N63 B44 O 0/N63 B40 O 1/N63 B44 O 1 | 3 Nm | ||