13 71 Intake silencer
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATIONS - INTAKE SILENCER
| Type | Thread | Tightening specifications | Dimension | ||
|---|---|---|---|---|---|
| 1AZ | Raw air diversion to lock support | N55/N55 Hybrid | 6 Nm | ||
| 2AZ | Intake silencer upper part to lower part | N55/N55 Hybrid | 2.5 Nm | ||
| 3AZ | Clean air pipe to intake silencer | N55/N55 Hybrid | Clamp | 3 Nm | |
| 4AZ | Hot film air mass meter to top clean air pipe | N55/N55 Hybrid | 2 Nm | ||
| 5AZ | Clean-air duct to cylinder head cover | N55/N55 Hybrid | 3 Nm | ||
| 6AZ | Upper clean air pipe to lower clean air pipe | N55/N55 Hybrid | Clamp | 3 Nm | |
| 7AZ | Lower clean air pipe to air duct | N55/N55 Hybrid | 3 Nm | ||
| 8AZ | Air duct to exhaust turbocharger | N55/N55 Hybrid | 8 Nm | ||
| 9AZ | Lower air duct to cylinder head | N55/N55 Hybrid | 8 Nm | ||
| 10AZ | Lower charge-air duct to upper charge-air duct | N55/N55 Hybrid | 3 Nm | ||