13 51 Injection pump, control
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATIONS - INJECTION PUMP, CONTROL
| Type | Thread | Tightening specifications | Dimension | ||
|---|---|---|---|---|---|
| 1AZ | High-pressure pump to cylinder head cover | N63 B44 O 0/N63 B40 O 1/N63 B44 O 1 | M6 | Replace screws. Tighten bolts to final torque/angle in uniform increments of 90°. Follow applicable repair instructions. |
12 Nm |