51 47 Floor trim, luggage compartment and engine compartment trim panels
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATIONS - FLOOR TRIM, LUGGAGE COMPARTMENT AND ENGINE COMPARTMENT TRIM PANELS
| Type | Thread | Tightening specifications | Dimension | ||
|---|---|---|---|---|---|
| 1AZ | Roller cover for luggage compartment frame to body | F07 | M8x22 | 17.5 Nm | |
| 2AZ | Luggage compartment removable panel hinge on rear luggage compartment to body | F07 | 3.3 Nm | ||
| 3AZ | Tail panel cover to transmission cross-member | F07 | 2 Nm | ||
| F15/F85/F86 | 3 Nm | ||||
| 4AZ | Screw connection, lashing eyes | F07/F11 | 6 Nm | ||
| F06/F12/F13 | 20.5 Nm | ||||
| 5AZ | Stud, rail cover | F07 | 6 Nm | ||
| 6AZ | Screw connection, rail support | F07 | Replace screws | 8 Nm | |
| 7AZ | Roller cover for luggage compartment lock to body | F07 | Replace screws | 8 Nm | |
| 8AZ | Screen trim, center | F07 | 1.8 Nm | ||
| 9AZ | Lock/housing to roller cover for luggage compartment (center) | F07 | 2.3 Nm | ||
| 10AZ | Lock to retaining bracket | F07 | 25 Nm | ||
| 11AZ | Locking bracket to roller cover for luggage compartment (center) | F07 | 8 Nm | ||
| 12AZ | Mounting, cargo cover, to frame, cargo cover | F07 | 12 Nm | ||
| 13AZ | Screw connection, underbody protection | F03 | 19 Nm | ||
| 14AZ | Load area net cover mounting | F11 | 2.5 Nm | ||
| 15AZ | Lashing rail to body | F25/F26 | 12 Nm | ||
| F15/F16/F85/F86 | 20 Nm | ||||
| 16AZ | Mounting for roller cover | F25 | 7.6 Nm | ||
| F85/F86 | 8 Nm | ||||
| 17AZ | Battery cover to body | F15/F85/F86 | 3 Nm | ||
| 18AZ | Shoulder to body | F15 | 3 Nm | ||
| F85/F86 | 6 Nm | ||||
| 19AZ | Trim panel, D-pillar bottom to body | F15/F85/F86 | 3 Nm | ||
| 20AZ | Trim panel for luggage compartment floor on body | F15 | Flat-head screw M8x18 |
8.5 Nm | |
| Sheet metal screw ST 4, 8x19 |
3 Nm | ||||