67 10 522 Replacing (removing and installing) the drive unit for rear view camera

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Necessary preliminary tasks:

Unlock plug connections (3) and (4) and disconnect.

Release screws (1) and (2).

Remove drive unit (5).

Fig 1: Identifying Drive Unit Plug Connections And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

The operation emblem (1) must be completely closed when installing the drive unit.

The operating lever (2) on the operating emblem (1) must be connected correctly with the guide in the drive unit.

Fig 2: Identifying Operating Lever And Operating Emblem

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement: