67 61 005 Removing and installing (replacing) electric motor with gearbox (front) for operation of glass tilt sunroof

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Necessary preliminary tasks:

NOTE: Secure electric motor with gearbox for operation of glass tilt sunroof (3) against falling out.

Unfasten plug connection (1) and disconnect.

Unfasten screws (2).

Tightening torque 54 13 1AZ .

NOTE: Screws (1) are microencapsulated.

Thread out and remove the electric motor and transmission for the glass tilt sunroof operation (3) from the headlining (4).

Fig 1: Identifying Glass Tilt Sunroof, Plug Connection And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Insert gear (1) of electric motor with gearbox for operation of glass tilt sunroof (2) exactly in gearing (3).

Fig 2: Identifying Gear, Teeth, And Slide/Tilt Sunroof Electric Motor

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: