67 65 010 Removing and installing or replacing drive unit for roller sunblind

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

Cut open cable strap (2).

Installation note:

Cable strap (2) must be renewed.

Disconnect plug connection (3).

Release screws (4).

Remove electric motor (1) with drive linkage.

Fig 1: Identifying Electric Motor, Plug Connection, Cable Strap, And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (3).

Remove electric motor (1) from drive linkage (2).

Installation note:

Drive linkage (2) can only be installed in one position.

Fig 2: Identifying Electric Motor, Drive Linkage, Screw

Courtesy of BMW OF NORTH AMERICA, INC.